The fully automatic baler is composed of a body frame, transmission organization, feeding organization, density adjustment organization, grass pressure piston organization, grass bundle length control organization, wheel walking organization, picker, grass roller, sprocket transmission organization, rope box, rope rod and warning equipment, hydraulic control organization, etc.
The tractor drives the feeding pressure plate and piston to perform reciprocating motion through the transmission organization to drive the connecting rod; Straw enters the grass storage chamber through the feeding port, under the action of the feeding pressure plate, and is then pushed in and pressed forward by the grass pressing piston. When bundling, automatic rope guidance, automatic picking of straw crops, automatic bundling, and automatic rope cutting. By adjusting the size of the groove wheel, the density of the rope loops and bales during bundling can be changed to prevent the bales from becoming loose or messy.
The advantages of automatic balers help reduce environmental pollution and maintain the ecological environment. The smoke, carbon dioxide, and sulfur dioxide produced by burning crop straw can cause environmental pollution, affect air quality, and pose a threat to people's health. Increasing the comprehensive utilization of crop straw can improve the overall utilization rate of straw, effectively reduce straw burning, avoid straw pollution of water sources, and maintain the ecological environment.
Helps to improve the utilization value of straw and develop a circular economy. Crop straw is an important biomass resource with a wide range of uses. It is not only a substitute for coal, electricity, oil, gas and other power sources, but also a base material for feed, fertilizer, edible fungi, and industrial raw materials. Strengthening the comprehensive utilization of straw can reduce the consumption of other resources, promote the sustainable use of resources, and promote the development of circular economy.
Troubleshooting method for fully automatic silage baler: The baler does not automatically feed, the potentiometer for controlling the length of the baler feed is zero, and the potentiometer for controlling the length of the baler feed is located on the front panel switch card in two directions from the left. If adjusted clockwise, the length of the strap will be very short, and if in the zero direction, the strap will not come out. The strapping machine does not correctly thread the straps. Open the right door and thread the straps correctly according to the "threading process method" or threading diagram indicated in the manual. There is a foreign object in the upper and lower units of the baler. The baler has been used for a long time and has not been cleaned and maintained in a timely manner, resulting in the accumulation of dirt inside the machine and making the conveyor belt not smooth. More cleaning and maintenance should be done.
